An infrared panel in a shower room requires assessment of both the exact model and its installation location. Do not assume blanket permission from an IP rating or product photo. The manufacturer must permit the use and installation; a qualified installer must also assess the electrical installation and locally applicable requirements.
Key considerations
Record the country, floor plan, shower position, intended panel location and electrical connection before ordering. Check the model manual and heat loss. A panel does not automatically make the room mould-free or replace ventilation.
Assess the application first
Decide whether you want whole-bathroom heating or targeted supplementary warmth. Insulation, ventilation, desired temperature and usage duration determine heat demand. A panel suitable elsewhere in the bathroom is not automatically suitable inside or above the shower. Assess comfort and safe clearances for the chosen location too.
Protection zones and product suitability
Installation requirements vary by country and situation. NEN 1010 is relevant in the Netherlands and AREI in Belgium. The applicable edition, protection zones and any transitional provisions must be established for the project. Do not mix Dutch and Belgian rules or apply them to installations in other countries without assessment.
An IP rating describes a form of ingress protection. It does not by itself prove that every mounting location, connection or cleaning method is permitted. Have location, product approval, electrical protection, controls and accessibility assessed together. A fixed connection does not automatically remove other requirements.
Wall or ceiling installation
Use only an installation method permitted by the manufacturer. Check load-bearing capacity, fixings, required clearances and maintenance access. Consider hot surfaces and possible contact. Do not move or install a panel closer to people, water or materials to increase its effect without checking the instructions.
Moisture and ventilation still need separate attention
Warmer surfaces can affect condensation, but heating does not remove moisture from the room. Keep ventilating and address leaks, thermal bridges or other moisture sources. There is no general guarantee that an infrared panel prevents mould, sufficiently heats the floor or independently controls humidity.
Information for a suitable proposal
We advise private and business end users and also supply installers and wholesalers. Send room dimensions, insulation data, installation country, intended location and any product codes. We help compare product data and controls; a final installation assessment is still needed for the specific situation.
See our Welltherm bathroom panels and check each version’s suitability for the intended location.
An informed heating plan
Compare comfort, purchase, installation, controls and consumption. Power in kW multiplied by actual operating hours gives consumption in kWh; multiply by your electricity tariff. Fixed warm-up time, service life or savings require substantiated data for the selected model and use.
Frequently asked questions
Can every bathroom panel go above the shower?
No. Product suitability, location, electrical protection and applicable requirements must all be satisfied. A general shop description is not sufficient.
Can I connect or clean the panel myself?
Have work requiring specialist knowledge carried out by a qualified person. Clean only as specified in the model manual, using permitted agents and prescribed safe conditions. Splash protection does not permit spraying down or immersing the device.